Media Di-Box Palmer LI 04 (PC/ Laptop'ui)
Prekės kodas: |
PLI04 |
Papildoma informacija: |
|
266.00 EUR
Skirtas spec. media priemonėms. IN: 2x 6,3 mm TRS- Jack, 2x RCA Phono, 1x 3,5 mm stereo Jack. OUT: 2x XLR (M) Pagaminta Vokietijoje, 5m garantija!
PRO MEDIA DI/ PLI-04. With the new PRO MEDIA DI/ PLI-04, Palmer introduces a DI-box, produced with the discerning needs of the computer-age media in mind. Using this uncomplicated method, personal computers and other consumer equipment with unbalanced outputs can be converted to balanced, in order to carry out, e.g., a presentation over a professional PA system. The PLI-04 accommodates all the common input types, TRS jacks accepting mono or stereo plugs, RCA phono sockets and a 3.5mm stereo jack input for use with the headphone output of a Laptop or similar device. The outputs are conventional transformer balanced XLR sockets, as used in professional PA systems, guaranteeing an electrically decoupled signal, a prerequisite to ensure noise-free operation. One other special feature which should not be forgotten! Although the PLI-04 is primarily a stereo unit, it can be switched to mono, with the two stereo signals summed and fed to both XLR outputs. The PLI-04 manifests a mechanically robust unit combined with outstanding technical specifications, adding to the list of high quality products that have come to be expected from Palmer.
PLI04 Specifications:
Inputs:
* 2x 6.3mm TRS-Jack
* Tip= +phase (hot)
* Ring= -phase (cold)
* Sleeve= screening
* Ground
* 2x RCA phono sockets
* 1x 3.5mm stereo jack
* Input Impedance: 6 kohms at 600 ohms
* Load Input Level: 6dBu 30Hz/0.05%THD 16dBu 30Hz/0.33%THD (All measurements taken with 200 ohms source)
Outputs:
* 2x XLR male
* Pin 1 ground
* Pin 2 pos. phase (hot)
* Pin 3 neg. phase (cold)
* Transformer balanced
* Output Impedance: 600 ohms
* Gain reduction input to output: 10dB
* Transformer ratio: 3.16 : 1
* Frequency response: 20Hz - 20kHz ± 0.5dB
* Phase response: less than 3°degree deviation
* Mono switch 3 position ground lift switch: lift, ground, soft ground
* Aluminium die cast housing: 125 x 95 x 35 mm
|